1.Open the battery cover, and install 1 (AA)battery in accordance with the
instructions, then replace the battery cover.
2 Push the power switch to the position “LOW” or ”HI”, power supply has
been connected and the light will be bright. If the emitter is opened and it
receives signal, the power indicator light will be brighter.
a.When push the switch to “HI”, the output level is 900mv, which is suitable
for computers, small audio power amplifiers and monitors
b.When push the switch to “LOW”, the output level is 500mv, which is
suitable for normal audio power amplifiers.
3.Insert φ6.35 plug into the power amplifiers or input jacks of other devices.
Please note: The volume should be increased from the lowest gradually.
4.Insert the USB plug into the receiver without removing the battery inside,
if you don't need battery to support.
5. After using, push the switch to the position “OFF”.
6.When the power light goes out or dims, the sound of output is distorted and
working distance is shorter, this indicates low battery. It's better to replace
batteries.
7.Must unfasten the antenna, the antenna direction will affect the receiving
distance
* Waist hanging microphone
1.Capacitor core
2.Audio line and ANT
3.Microphone plug
4.Microphone input jack
5.Power indicator and voltage
indicator light
6.Power switch
7.Sound sensitivity adjustment
8.Belt clip
9.Battery cover
10.Battery compartment
1.Open the battery cover, and install batteries (9V) in accordance with the
instructions. Pay attention to the positive and negative polarity
2.Insert the plug into the input interface of transmitter and tighten it. Another
end can be nipped on the collar or wear on the head.
3.Push the switch to the position “ON”, power light flashes once, then
immediately put out which is normal. If the light is long bright, it indicates
low battery. It's better to replace battery to protect products.
4.Push the switch to the intermediate, the clip microphone will shut its
adapterization function. When push to “ON”, it can be used to speak
5.According to need, adjust the knob of microphone sensitivity to the
appropriate position.(Increase-clockwise; decrease-counterclockwise)
Standard configuration
1.Host computer:1
2.Transmitter waist hanging:1
3.Battery (5 # 1.5v):3
4.Instructions : 1
5.Packaging : 1
1.Open the battery cover, and install batteries (9V) in accordance with the Insert the plug into the input interface of transmitter and tighten it. Another
3.Push the switch to the position “ON”, power light flashes once, then immediately put out which is normal. If the light is long bright, it indicates low battery. It's better to replace battery to protect products
4.Push the switch to the intermediate, the clip microphone will shut its adapterization function. When push to “ON”, it can be used to speak
5.According to need, adjust the knob of microphone sensitivity to the appropriate position.(Increase- clockwise;decrease- counterclockwise)
*Technology data
1. Frequency: VHF210-266
2. Modulation system: FM
3. Mode of oscillation: Quartz oscillation±0.005%
4. Signal to Noise Ratio: !#!gt!*!80dB
5. Audio frequency response:45HZ-16KHZ
6. Comprehensive distortion:≤0.5%
7.Working distance:50m
8. Reception channel:Signal
9. Output level:500mv or 900mv
10. Receive size r: 94x18.5x53mm
11. Transmitter size : 240x36mm(Handheld)
12.Transmitter size : 95x65x23mm(Waist hanging)
13. Receiver using voltage :1.5v(5#), power consumption≤60mA
14. Handheld voltage :1.5v(5#)x2, power consumption≤100mA
15.Waist hanging using voltage:9v, power consumption≤35mA